CESSNA 310Q — Service Bulletins

This service bulletin, MEB-27-02, addresses the replacement of the hardware securing the elevator trim push-pull rod on various Cessna aircraft models, including the Cessna 414. It outlines mandatory compliance requirements, detailing the steps necessary to replace the hardware connecting the elevator trim push-pull tube to the elevator trim actuator and elevator trim tab. The bulletin emphasizes the importance of using the correct parts and following the specified procedures to ensure safety and compliance. It is intended for maintenance personnel and aircraft owners who must adhere to the outlined instructions during inspections and maintenance activities.

• Mandatory compliance at next 100-hour or 12-month inspection.
• Visual inspection required during subsequent inspections.
• Use correct cotter pin part number MS24665-132 to prevent hardware loosening.
• Installation kit includes NAS464P3-8 bolts, NAS1149F0332P washers, MS17826-3 nuts, and MS24665-132 cotter pins.
• Document must be recorded in the aircraft logbook after compliance.