cessna model u206g - flight examiners

supplied with your airplane. Warranty service is available to you at authorized Cessna Dealers throughout the world upon presentation of your Customer Care Card which establishes your eligibility under the warranty. FACTORY TRAINED PERSONNEL to provide you with courteous expert service. FACTORY APPROVED SERVICE EQUIPMENT to provide you efficient and accurate workmanship. A STOCK OF GENUINE CESSNA SERVICE PARTS on hand when you need them. THE LATEST AUTHORITATIVE INFORMATION FOR SERVICING CESSNA AIR- PLANES, since Cessna Dealers have all of the Service Manuals and Parts Catalogs, kept current by Service Letters and Service News Letters, published by Cessna Aircraft Company. We urge all Cessna owners to use the Cessna Dealer Organization to the fullest. A current Cessna Dealer Directory accompanies your new airplane. The Directory is revised frequently, and a current copy can be obtained from your Cessna Dealer. Make your Directory one of your cross-country flight planning aids; a warm welcome awaits you at every Cessna Dealer. 29 August 1980 THIS MANUAL WAS PROVIDED FOR THE AIRPLANE IDENTIFIED ON THE TITLE PAGE ON 10-24.80 SUBSEQUENT REVISIONS SUPPLIED BY CESSNA AIRCRAFT COMPANY MUST BE PROPERLY IN- SERTED O ndat о CESSNA AIRCRAFT COMPANY, PAWNEE DIVISION о о о :0 PILOT'S OPERATING HANDBOOK and FAA APPROVED AIRPLANE FLIGHT MANUAL ب CESSNA AIRCRAFT COMPANY о THIS DOCUMENT MUST BE CARRIED IN THE AIRPLANE AT ALL TIMES. 1981 MODEL U206G. Serial No. 420605964 Registration No.2 о THIS HANDBOOK INCLUDES THE MATERIAL REQUIRED TO BE FURNISHED TO THE PILOT BY CAR PART 3 AND CONSTITUTES THE FAA APPROVED AIRPLANE FLIGHT MANUAL. Member of GAMA COPYRIGHT © 1980 CESSNA AIRCRAFT COMPANY WICHITA, KANSAS, USA 29 August 1980 CESSNA MODEL U206G SECTION 1 GENERAL TABLE OF CONTENTS SECTION 1 GENERAL Page Three View Introduction Descriptive Data Engine 1-2 . 1-3 о Propeller Fuel Oil Maximum Certificated Weights Standard Airplane Weights Cabin And Entry Dimensions 1-3 1-3 1-3 1-3 1-4 1-4 1-5 1-5 Baggage Space And Cargo Door Entry Dimensions 1-5 Specific Loadings 1-5 Symbols, Abbreviations And Terminology 1-5 о x General Airspeed Terminology And Symbols 1-5 Meteorological Terminology 1-6 Engine Power Terminology 1-6 Airplane Performance And Flight Planning Terminology Weight And Balance Terminology 1-7 1-7 29 August 1980 1-1 SECTION 1 GENERAL 9'-3 1/2" MAX. CESSNA MODEL U206G NOTES: 1. Dimensions shown are based on standard empty weight and pro- per nose gear and tire inflation. 2. Dimensions shown reflect standard nose and main gear tire installation. 3. Wing span shown with strobe lights installed. 4. Maximum height shown with nose gear depressed as far as possible. 5. Wheel base length is 69 1/4”. 6. Propeller ground clearance is 11 3/4". 7. Wing area is 174 square feet. 8. Minimum turning radius (✶ pivot point to outboard wing tip} is 26'-3". -28'-3"- -13'-0”. о о C 1-2 * 0 PIVOT POINT -36'-0”- -8'-1"- -80" * PIVOT POINT Figure 1-1. Three View 29 August 1980 о O о о о CESSNA MODEL U206G INTRODUCTION SECTION 1 GENERAL This handbook contains 9 sections, and includes the material required to be furnished to the pilot by CAR Part 3. It also contains supplemental data supplied by Cessna Aircraft Company. Section 1 provides basic data and information of general interest. It also contains definitions or explanations of symbols, abbreviations, and terminology commonly used. DESCRIPTIVE DATA ENGINE Number of Engines: 1. Engine Manufacturer: Teledyne Continental. Engine Model Number: IO-520-F. Engine Type: Normally-aspirated, direct-drive, air-cooled, horizontally- opposed, fuel-injected, six-cylinder engine with 520 cu. in. displace- ment. Horsepower Rating and Engine Speed: Maximum Power (5 minutes - takeoff): 300 rated BHP at 2850 RPM. Maximum Continuous Power: 285 rated BHP at 2700 RPM. PROPELLER Propeller Manufacturer: McCauley Accessory Division. Propeller Model Number: D3A34C404/80VA-0. Number of Blades: 3. Propeller Diameter, Maximum: 80 inches. Minimum: 78.5 inches. Propeller Type: Constant speed and hydraulically actuated, with a low pitch setting of 11.0° and a high-pitch setting of 27.0° (30 inch station). FUEL Approved Fuel Grades (and Colors): 100LL Grade Aviation Fuel (Blue). 100 (Formerly 100/130) Grade Aviation Fuel (Green).. NOTE Isopropyl alcohol or ethylene glycol monomethyl ether may be added to the fuel supply. Additive concentrations shall not exceed 1% for isopropyl alcohol or 15% for ethylene glycol monomethyl ether. Refer to Section 8 for 29 August 1980 1-3 SECTION 1 GENERAL CESSNA MODEL U206G additional information. Total Capacity: 92 gallons. Total Capacity Each Tank: 46 gallons. Total Usable: 88 gallons. OIL Oil Grade (Specification): MIL-L-6082 Aviation Grade Straight Mineral Oil: Use to replenish supply during first 25 hours and at the first 25-hour oil change. Continue to use until a total of 50 hours has accumulated or oil consumption has stabilized. NOTE The airplane was delivered from the factory with a corro- sion preventive aircraft engine oil. This oil should be drained after the first 25 hours of operation. Continental Motors Specification MHS-24 (and all revisions thereto), Ashless Dispersant Oil: This oil must be used after first 50 hours or oil consumption has stabilized. Recommended Viscosity for Temperature Range: All temperatures, use SAE 20W-50 or Above 4°C (40°F), use SAE 50 Below 4°C (40°F), use SAE 30 NOTE Multi-viscosity oil with a range of SAE 20W-50 is recom- mended for improved starting in cold weather. Oil Capacity: Sump: 12 Quarts. Total: 13 Quarts (if oil filter installed). MAXIMUM CERTIFICATED WEIGHTS о о о о Ramp: 3612 lbs. Takeoff: 3600 lbs. Landing: 3600 lbs. Weight in Baggage Compartment Station 109 to 145: 180 lbs maximum. NOTE Refer to Section 6 of this handbook for loading arrange- ments with one or more seats removed for cargo accommo- 1-4 dation. 29 August 1980 CESSNA MODEL U206G SECTION 1 GENERAL STANDARD AIRPLANE WEIGHTS Standard Empty Weight, Stationair 6: 1928 lbs. AZN is 206516 Stationair 6 II: 1989 lbs. Utility Stationair 6: 1882 lbs. Utility Stationair 6 II: 1942 lbs. Maximum Useful Load, Stationair 6: 1684 lbs. Stationair 6 II: 1623 lbs. Utility Stationair 6: 1730 lbs. Utility Stationair 6 II: 1670 lbs. AZN 15351b CABIN AND ENTRY DIMENSIONS Detailed dimensions of the cabin interior and entry door opening are illustrated in Section 6. BAGGAGE SPACE AND CARGO DOOR ENTRY DIMENSIONS Dimensions of the baggage/cargo area and cargo door opening are illustrated in detail in Section 6. о SPECIFIC LOADINGS о Wing Loading: 20.7 lbs./sq. ft. Power Loading: 12.0 lbs./hp. о о SYMBOLS, ABBREVIATIONS AND TERMINOLOGY GENERAL AIRSPEED TERMINOLOGY AND SYMBOLS KCAS KIAS KTAS VA Knots Calibrated Airspeed is indicated airspeed corrected for position and instrument error and expressed in knots. Knots calibrated airspeed is equal to KTAS in standard atmosphere at sea level. Knots Indicated Airspeed is the speed shown on the airspeed indicator and expressed in knots. Knots True Airspeed is the airspeed expressed in knots relative to undisturbed air which is KCAS corrected for altitude and temperature. Manuevering Speed is the maximum speed at which you may use abrupt control travel. 29 August 1980 1-5 SECTION 1 GENERAL CESSNA MODEL U206G √ FE VNO VNE VS མར Vy i Maximum Flap Extended Speed is the highest speed permissible with wing flaps in a prescribed extended position. Maximum Structural Cruising Speed is the speed that should not be exceeded except in smooth air, then only with caution. Never Exceed Speed is the speed limit that may not be exceeded at any time. Stalling Speed or the minimum steady flight speed at which the airplane is controllable. Stalling Speed or the minimum steady flight speed at which the airplane is controllable in the landing configu- ration at the most forward center of gravity. Best Angle-of-Climb Speed is the speed which results in the greatest gain of altitude in a given horizontal distance. Best Rate-of-Climb Speed is the speed which results in the greatest gain in altitude in a given time. METEOROLOGICAL TERMINOLOGY OAT Outside Air Temperature is the free air static temperature. It is expressed in either degrees Celsius or degrees Fah- renheit. Standard Temperature is 15°C at sea level pressure alti- tude and decreases by 2°C for each 1000 feet of altitude. о о Standard Tempera- ture Pressure Altitude Pressure Altitude is the altitude read from an altimeter when the altimeter's barometric scale has been set to 29.92 inches of mercury (1013 mb). ENGINE POWER TERMINOLOGY BHP RPM MP Brake Horsepower is the power developed by the engine. Percent power values in this handbook are based on the maximum continuous power rating. Revolutions Per Minute is engine speed. Manifold Pressure is a pressure measured in the engine's 1-6 29 August 1980 о CESSNA MODEL U206G SECTION 1. GENERAL induction system and is expressed in inches of mercury (Hg). AIRPLANE PERFORMANCE AND FLIGHT PLANNING TERMINOLOGY о о Demon- strated Crosswind Velocity Usable Fuel Unusable Fuel GPH NMPG 80 g Demonstrated Crosswind Velocity is the velocity of the crosswind component for which adequate control of the airplane during takeoff and landing was actually demon- strated during certification tests. The value shown is not considered to be limiting. Usable Fuel is the fuel available for flight planning. Unusable Fuel is the quantity of fuel that can not be safely used in flight. Gallons Per Hour is the amount of fuel (in gallons) consumed per hour. Nautical Miles Per Gallon is the distance (in nautical miles) which can be expected per gallon of fuel consumed at a specific engine power setting and/or flight configura- tion. g is acceleration due to gravity. WEIGHT AND BALANCE TERMINOLOGY Reference Datum Station о Arm Moment Center of Gravity (C.G.) 29 August 1980 Reference Datum is an imaginary vertical plane from which all horizontal distances are measured for balance purposes. Station is a location along the airplane fuselage given in terms of the distance from the reference datum. Arm is the horizontal distance from the reference datum to the center of gravity (C.G.) of an item. Moment is the product of the weight of an item multiplied by its arm. (Moment divided by the constant 1000 is used in this handbook to simplify balance calculations by redục- ing the number of digits.) Center of Gravity is the point at which an airplane, or equipment, would balance if suspended. Its distance from the reference datum is found by dividing the total moment 1-7 SECTION 1 GENERAL CESSNA MODEL U206G C.G.. Arm C.G. Limits Standard Empty Weight Basic Empty Weight Useful Load Maximum Ramp Weight Maximum Takeoff Weight Maximum Landing Weight Tare by the total weight of the airplane. Center of Gravity Arm is the arm obtained by adding the airplane's individual moments and dividing the sum by the total weight. Center of Gravity Limits are the extreme center of gravity locations within which the airplane must be operated at a given weight. Standard Empty Weight is the weight of a standard air- plane, including unusable fuel, full operating fluids and full engine oil. Basic Empty Weight is the standard empty weight plus the weight of optional equipment. Useful Load is the difference between ramp weight and the basic empty weight. Maximum Ramp Weight is the maximum weight approved for ground maneuver. (It includes the weight of start, taxi and runup fuel.) Maximum Takeoff Weight is the maximum weight ap- proved for the start of the takeoff run. Maximum Landing Weight is the maximum weight ap- proved for the landing touchdown. Tare is the weight of chocks, blocks, stands, etc. used when weighing an airplane, and is included in the scale read- ings. Tare is deducted from the scale reading to obtain the actual (net) airplane weight. о о о 1-8 29 August-1980 О CESSNA MODEL U206G SECTION 2 LIMITATIONS SECTION 2 LIMITATIONS TABLE OF CONTENTS Introduction Airspeed Limitations Airspeed Indicator Markings Power Plant Limitations Power Plant Instrument Markings Weight Limits • Center Of Gravity Limits о о о Maneuver Limits Flight Load Factor Limits Kinds Of Operation Limits Fuel Limitations Other Limitations Flap Limitations Placards Page 2-3 2-4 2-4 2-5 2-6 2-7 2-7 2-7 2-7 2-8 2-8 2-8 2-8 2-9 29 August 1980 2-1/(2-2 blank)