Mooney M20A — Avionics Manual

This manual provides detailed instructions for the installation of SkyView Autopilot servos and associated bracketry specifically for the Mooney M20J and M20K aircraft models. It is intended for use by FAA-certified Airframe and Powerplant Technicians who possess the necessary knowledge and training to perform the outlined procedures. The document emphasizes the importance of following the specified guidelines to ensure compliance with airworthiness standards and to maintain the integrity of the aircraft's systems. It includes information on installation compliance, necessary tools, and safety precautions, as well as references to additional documentation for calibration and maintenance of the autopilot system.

• This manual is for Mooney M20J and M20K aircraft models.
• Installation must comply with STC SA02594SE and FAA regulations.
• Technicians should ensure all flight control bellcranks are lubricated before installation.
• Pitch and yaw servos must be installed with careful attention to alignment and positioning.
• Over-tightening servo castle nuts can lead to failure; follow torque specifications.