Skip to main content

AIRWORTHINESS DIRECTIVE

Beechcraft King Air 200 · Other Documents

Free account — keep the POHs & checklists you reference in one place.

Overview

This document is an Airworthiness Directive (AD) issued by the Civil Aviation Safety Authority (CASA) of Australia concerning the Beechcraft 200 series aircraft, including models 200, 200C, 200CT, 200T, A200, A200C, A200CT, B200, B200C, B200CT, and B200T. The directive addresses the need for revisions to the Aircraft Flight Manual (AFM) to enhance safety during flight in severe icing conditions. It outlines specific limitations and procedures that pilots must follow to mitigate risks associated with icing, including visual cues for identifying severe icing and actions to take if such conditions are encountered. Compliance with this directive is mandated within 30 days of its effective date, which is 13 July 2000.

  • Severe icing may occur in conditions outside the aircraft's certification limits.
  • Visual cues for severe icing include extensive ice accumulation on the airframe and wings.
  • Pilots must request priority handling from ATC if severe icing conditions are observed.
  • Do not engage the autopilot in severe icing conditions; it may mask handling cues.
  • Flaps should not be extended in icing conditions to prevent ice accumulation.

Document

Source

Originally published by services.casa.gov.au. Sprinkle hosts a reference copy with an added summary, specifications and searchable full text.

Report a problem or request removal

Document details

Type
Other Documents
Year
2000
Pages
4
File size
28 KB
Publisher
services.casa.gov.au
How rare is it?
2Beechcraft King Air 200 registered worldwide · 0 active

Common. Rarer than 17% of the aircraft models we track.

Documentation completeness
3/7

Most owners only have the POH. Here's the essential set for the Beechcraft King Air 200.

More Beechcraft King Air 200manuals & documents

See all 21
Similar aircraft

If you fly the Beechcraft King Air 200, you may also be researching these.

In this document

Limitations Section Revision

The AD requires revisions to the Limitations Section of the AFM to include warnings about severe icing conditions. It specifies that severe icing may occur outside the aircraft's certification limits, particularly in freezing rain or mixed icing conditions. Pilots are instructed to identify visual cues indicating severe icing and to request priority handling from Air Traffic Control if such cues are observed.

Normal Procedures Section Revision

The AD mandates updates to the Normal Procedures Section of the AFM, detailing weather conditions conducive to severe in-flight icing. It emphasizes the importance of monitoring ambient air temperature and provides procedures for exiting severe icing environments, applicable from take-off to landing.

Compliance Requirements

The directive states that compliance must be achieved within 30 days of the amendment's effective date. It also notes that certification for compliance can be performed by individuals holding a private pilot's license.

Safety notes

  • Severe icing may degrade aircraft performance and controllability.
  • Use of autopilot is prohibited in severe icing conditions.
  • All wing icing inspection lights must be operative before flight into known icing conditions.

Full document text

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES Beechcraft 200 (Super King Air) Series Aeroplanes AIRWORTHINESS DIRECTIVE For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/BEECH 200/66 and issues the following AD under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section. AD/BEECH 200/66 Amdt 1 Aircraft Flight Manual, Flight into Icing Conditions 7/2000 Applicability: Models 200, 200C, 200CT, 200T, A200, A200C, A200CT, B200, B200C, B200CT and B200T. Requirement: Revise: 1. the Limitations Section of the aircraft's Aircraft Flight Manual (AFM) by incorporating the following: "WARNING" Severe icing may result from environmental conditions outside of those for which the aircraft is certificated. Flight in freezing rain, freezing drizzle, or mixed icing conditions (super cooled liquid water and ice crystals) may result in: • ice build-up on protected surfaces and exceed the capability of the ice protection system, or • may result in ice forming aft of the protected surfaces. This ice may not be shed using the ice protection systems, and may seriously degrade the performance and controllability of the aircraft. During flight, severe icing conditions that exceed those for which the aircraft is certificated shall be determined by the visual cues described below. If one or more of these visual cues exists, immediately request priority handling from Air Traffic Control to facilitate a route or an altitude change to exit the icing conditions. The cues are: • unusually extensive ice accumulation on the airframe and windscreen in areas not normally observed to collect ice, and/or • accumulation of ice on the upper surface of the wing aft of the protected area, and/or • accumulation of ice on the engine nacelles and propeller spinners farther aft than normally observed. COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES Since the auto-pilot, when installed and operating, may mask tactile cues that indicate adverse changes in handling characteristics, use of the auto-pilot is prohibited when any of the visual cues specified above exist, or when unusual lateral trim requirements or auto-pilot trim warnings are encountered while the aircraft is in icing conditions. All wing icing inspection lights must be operative prior to flight into known or forecast icing conditions at night. This direction supersedes any relief provided by any Minimum Equipment List. 2. the Normal Procedures Section of the approved AFM by incorporating the following: THE FOLLOWING WEATHER CONDITIONS MAY BE CONDUCIVE TO SEVERE IN-FLIGHT ICING: • Visible rain at temperatures below 0 degrees Celsius ambient air temperature; • Droplets that splash or splatter on impact at temperatures below 0 degrees Celsius ambient air temperature. PROCEDURES FOR EXITING A SEVERE ICING ENVIRONMENT: (These procedures are applicable to all flight phases from take-off to landing.) Monitor the ambient air temperature. While severe icing may form at temperatures as cold as -18 degrees Celsius, increased vigilance is warranted at temperatures around freezing when visible moisture is present. COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES If the visual cues which are specified in the Limitations Section of the AFM for identifying severe icing conditions are observed, accomplish the following: • Immediately request priority handling from Air Traffic Control to facilitate a route or an altitude change to exit the severe icing conditions in order to avoid extended exposure to flight conditions more severe than those for which the aircraft has been certificated. • Avoid abrupt and excessive manoeuvring that may exacerbate control difficulties. • Do not engage the autopilot. • If the autopilot had previously been engaged, hold the control wheel firmly and disengage the autopilot. • If an unusual roll response or un-commanded roll control movement is observed, reduce the angle-of-attack. • Do not extend flaps when holding in icing conditions. Operation with flaps extended can result in a reduced wing angle-of-attack, with the possibility of ice forming on the upper surface further aft on the wing than normal, possibly aft of the protected area. • If the flaps are extended, do not retract them until the airframe is clear of ice. • Report these weather conditions to Air Traffic Control. Note 1: Certificate of Registration holders should initiate action to ensure notification of this change is conveyed to any person who may operate their aircraft as pilot in command. Note 2: FAA AD 98-20-38 refers. Certification for accomplishment of this Directive may be carried out: a. after a copy of this Directive is included in the appropriate sections of the aircraft's AFM; and b. may be carried out at a minimum, by the holder of a private pilot's licence. COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES Compliance: Within 30 days after the effective date of this Amendment. This Amendment becomes effective on 13 July 2000. Background: This Directive is issued to minimise the potential hazards associated with operating

Show full text

the aircraft in severe icing conditions by providing more clearly defined procedures and limitations associated with such conditions. Amendment 1 is raised to correct a word processing error in the initial issue. The original issue of this Airworthiness Directive became effective on 23 March 2000. Bernard Malcolm Hole Delegate of the Civil Aviation Safety Authority 31 May 2000 The above AD is notified in the Commonwealth of Australia Gazette on 14 June 2000.